dbaunach
RVF Newbee
- Joined
- Feb 16, 2022
- Messages
- 1
- Location
- Colville, Washington
- RV Year
- 1996
- RV Make
- Jayco
- RV Model
- Eagle SL 256
- RV Length
- 26'
- Fulltimer
- No
Hello everyone! I am very new to the forum and hope someone can shed a little light on the issue I'm having.
I purchased a used water tank and range hood to install in a complete RV rebuild that was previously gutted. The used range hood has a water tank gauge control panel built into it. It shows 1/4, 1/2, 3/4 & Empty levels. The tank also appears to have the 1/4 measurements rather than the 1/3rd levels. How would I determine where the wires connect? Do I need some kind of harness with resistors? I have included a photo of the circuit board as well as the tank. I can post a pic of the range hood if need be. It'd all taken apart at this time.
Thanks so much.
I purchased a used water tank and range hood to install in a complete RV rebuild that was previously gutted. The used range hood has a water tank gauge control panel built into it. It shows 1/4, 1/2, 3/4 & Empty levels. The tank also appears to have the 1/4 measurements rather than the 1/3rd levels. How would I determine where the wires connect? Do I need some kind of harness with resistors? I have included a photo of the circuit board as well as the tank. I can post a pic of the range hood if need be. It'd all taken apart at this time.
Thanks so much.