Invertor won't charge after LiFePO4 install

[Retired1]

I converted the original 6-Volt AGMs to LiPO4 in our 2017 London Aire, and now the SilverLeaf does not "see" the Xantrax invertor. Spoke with SilverLeaf and they had me do a reboot of the Xantrax, still nothing. So they felt it was a Xantrax problem. Spoke with Xantrax and they had me do a reboot with all house batteries, Chassis, and shore power off for 3 hours. It was late so I left everything off for overnight. Hooked everything back up this morning and Xantrax itself shows both "invertor enabled" and "AC In and charging" green lights that blink, which is what Xantrax said is correct. But still nothing on the SilverLeaf. Anybody have any ideas?
Bob

 

[redbaron]

Did you perhaps unplug the rvc connection on the xantrex?

 

[Retired1]

Did you perhaps unplug the rvc connection on the xantrex?

No, but after reading this I unplugged it, waited a few seconds and then re-plugged it it. SilverLeaf still not "seeing it" Thanks for the suggestion, though.