Resolved Another slide issue!

[Rustymayes]

So just as I am finishing a much needed cleaning and detail of the coach after the FWS caper, I find that the galley slide is not closing properly. The aft end is hanging open by about an inch. Multiple cycles give varying results non of which is fully closing. I checked the motors and mechanicals for any looseness and all seems fine. It seems to be a synchronization of the dual motor system that is the issue. Has anyone had to synch up their motors. Nothing in the Newmar manual of course. I did find that the Accent LED strip above the gally cabinets came loose and got caught in the aft lock and was pulled away. got it loose and out of the way but that did not fix the issue.
Thanks Rusty

 

[Neal]

Don't think it's hard to do.

Slide controller programming DCS-100 (dual motor)

Slide controller programming for KIB dual motor controller DCS 100

rvforums.com

 

[Rustymayes]

Disregard this transmission for now anyway.... I think the issue is solved. I found that the aft lock mechanism seemed a bit bound up and may have had a piece of the LED strip light caught in it at the top. I lubed and exercised the locks and now the room is functioning normally.

 

[Rustymayes]

Don't think it's hard to do.

Slide controller programming DCS-100 (dual motor)

Slide controller programming for KIB dual motor controller DCS 100

rvforums.com

Thanks Neal, I saved this to my Newmar manual folder for future reference.
Cheers