fire-medic
RVF Newbee
- Joined
- May 17, 2023
- Messages
- 1
Hello, first of all I'm a new member and I'm happy to that I found this forum. I don't know if this is the right place to ask this question so if you could either help me out or point me to the correct section to ask my question I would appreciate it.
Here's my problem I have a 2019 forest river grey wolf 29te. It has a lippert (schwintek) slideout.
I've looked all over YouTube and watched many videos about the lippert slideouts, including how to realign, using the controller, how they operate, etc. Excepting over found covers slideouts that are out of sync and replacing motors. But so far none of them have covered my exact problem. When moving my slide out I had to stop halfway (I didn't know that you shouldn't do that) and now only one side is moving while the other side does nothing. I'm not getting any codes from the controller and I can hear the motor spinning on the side that is not moving. Any help would be appreciated
Here's my problem I have a 2019 forest river grey wolf 29te. It has a lippert (schwintek) slideout.
I've looked all over YouTube and watched many videos about the lippert slideouts, including how to realign, using the controller, how they operate, etc. Excepting over found covers slideouts that are out of sync and replacing motors. But so far none of them have covered my exact problem. When moving my slide out I had to stop halfway (I didn't know that you shouldn't do that) and now only one side is moving while the other side does nothing. I'm not getting any codes from the controller and I can hear the motor spinning on the side that is not moving. Any help would be appreciated