Question Thread waste pipe into protective sleeve

[Joe Hogan]

Building an extension for the Sanicon system. Purchased a 20’ extension and a protection sleeve. Threading the sleeve onto the Sanicon pipe is a real challenge.

Any one find an easy way to do this?

 

[NWIP]

Not sure I would say easy but found it less difficult with the protective sleeve being somewhat wet. I worked a section at a time and held in place with zip ties until sleeve was fully on, fingers still sore

 

[Joe Hogan]

Zip ties to secure while in process, great idea!

 

[redbaron]

There is no easy way to do this..I have tried many methods to make it easier. Securing with zipties while working is the best option.

 

[Kevin D Pem]

Off topic slightly! I have a project that I need to sleeve some hoses together! Could you post a picture or two so I can inspect the sleeve construction?