Welcome to RVForums.com

  • Register now and join the discussion
  • Friendliest RV Community on the web
  • Modern site for PC's, Phones, Tablets - no 3rd party apps required
  • Ask questions, help others, review campgrounds
  • Get the most out of the RV Lifestyle
  • Invite everyone to RVForums.com and let's have fun
  • Commercial/Vendors welcome

Resolved Block Heater

Welcome to RVForums.com

  • Register now and join the discussion
  • Modern secure site, no 3rd party apps required
  • Invite your friends and let's have fun
  • Commercial/Vendors welcome
  • Friendliest RV community on the web
20190224_085548.jpg
20190322_080955.jpg
 
20191114_140136.jpg

Pump sitting atop the module. The Oasis service manual has a blurb that shows there the coolant hoses and the pump power wiring is located on the left side. You remove the hose and place it on the output of the pump...then use a piece of htr hose with a 90 degree elbow in it to attach the module fitting to the pump intake. You'll find the length required to mate the parts and trim away excess hose...

The pump just has wires...so, you will habe to crimp insulated spade connectors to mate with the Oasis supplied wire bundle.
 
Thanks for all of that Charlie. Interesting…. I have the Oasis NE-s which is a large, all-in-one unit without a dist box….so I would need to see where it would go.

Thanks.
Rich
 
Update to whether or not block heater is operational.
1. Ohm check across hot and neutral of the plug for the heater: 19.8 to 20.0 ohms
2. 110 volts with 20 ohms = 5.5 amps (Ohm’s law)
3. Started generator, switched off inverter and charger. Amp draw on L2 = 2 amps
4. Plugged in the block heater. Amp draw = 8 amps
5. 8-2=6 within reason of the projected 5.5 from ohm’s law
Conclusion: all OK. Block heater element is good and circuitry feeding it is fine.

I was expecting a much larger draw on the generator at first, resulting in the original post. I was anticipating more like turning on an a/c and hearing the generator respond.

Thanks for responding and reading. Again, RV education. Every time I use it.

Anecdotally: LCD displays in the overhead are real slow and dim at 15 degrees above 0 F.
 

Latest resources

Back
Top