How do I turn the Xcite camera Left\Right Turn signal on

[BGMAC]

I’m not sure if this is the right model but here is a manual. Take a look at page 33. There is a manual operation.

https://riverparkinc.com/wp-content/uploads/2014/11/XSG2NA-X2-Infotainment-User-Manual-Generic-052014-ver03.pdf

 

[Stuart W]

Great info, it talkes about triggers, they would be the input sent from left or right or reverse control activation. Also to be able to hold the rear view It doesn’t indicate a software switch
So as ARD suggested check wires to the turn cameras, next would be to verify the trigger wires from R,L turn switch and Reverse input when shifted in Reverse. This should be at or near the back of the radio unit.

 

[Joe Hogan]

I believe this is the board that controls the cameras for Xcite

 

[Stuart W]

ARD was talking about connections to the cameras
I was talking about the trigger wires, both should be checked

 

[Stuart W]

Example: If you don’t want the camera to come on in reverse you could remove the reverse trigger wire

 

[BGMAC]

That just seems odd to me to have to pull wires to turn cameras on and off. I have several settings for turning cameras on and off, type of communication, contrast, etc. and it’s 8 yrs old.

 

[Stuart W]

That just seems odd to me to have to pull wires to turn cameras on and off. I have several settings for turning cameras on and off, type of communication, contrast, etc. and it’s 8 yrs old.

They look at those 3 views as safety so they don’t consider on off