Welcome to RVForums.com

  • Register now and join the discussion
  • Friendliest RV Community on the web
  • Modern site for PC's, Phones, Tablets - no 3rd party apps required
  • Ask questions, help others, review campgrounds
  • Get the most out of the RV Lifestyle
  • Invite everyone to RVForums.com and let's have fun
  • Commercial/Vendors welcome

New to Towing a Vehicle

Welcome to RVForums.com

  • Register now and join the discussion
  • Modern secure site, no 3rd party apps required
  • Invite your friends and let's have fun
  • Commercial/Vendors welcome
  • Friendliest RV community on the web
So I'm ready for the flack on this!

5000 is based on hitch weight. The hitch can handle 500. An equalizer hitch can change that 5000 number!

What concerns me is the warning about the vehicle capacity!!! Most front engine MHs have extended frames, and the joint has been known to fail. This applies to toweds as well as pull trailers.

In short, a class 3 receiver should be capable enough with an equalizer hitch, to pull the trailer loaded with your Jeep!!!! Just remember my warning about that compromised frame!!!
 
There are only three aftermarket bumpers rated for flat towing Jeep Wranglers, RockHard, LOD and Smittybilt. I have the Smittybilt which I installed myself. Roadmaster makes bumper D-ring adapters which also fit Demco tow bars. Blue Ox D-ring adapters only fit Blue Ox tow bars. You can buy a DIY plug n play wire harness with diodes for lights. All in, my JK was ready to be flat towed for less than $500. For supplemental braking cost/options, you need to determine what you need to be legal in your home jurisdiction only. Once compliant at home, reciprocity takes care of the rest.
I am DEFINITELY no expert on this, but I understood supplemental braking requirements had to be met for the specific state you are driving in. Your drivers license requirements fall under the reciprocity agreements but I don't believe that applies to requirements for supplemental braking systems.
 
I have the rockhard bumper on my 2020 rubicon. It is a great hitch.

One thing that is often overlooked is the need to be within 2 inches of center between the RV tow hitch and the bumper centerpoint.

Gas coaches often have a higher hitch receiver than the diesel coaches. I had to use 12" riser hitch from Gen-Y to get mine within 1.5" of center.
 
Regarding Supplemental brakes--I can tell you from personal experience that you want them. I had a breakaway this summer where my front bumper separated from the towbar on one side. This was a very scary moment. I was able to get the vehicle stopped using the one remaining connection, but this was a struggle to do while going down hill on a 2 lane highway. The jeep was in the oncoming lane, and required me to move over to shoulder a lot more than I wanted to. Had it broke away at that point, it would have killed someone in oncoming traffic.

I don't care about the laws, rules, or any other reasoning--Supplemental brakes are just common sense and will save a life.

If my vehicle killed someone because I was too cheap to do it right, I don't think I could live with myself.
 
Regarding Supplemental brakes--I can tell you from personal experience that you want them. I had a breakaway this summer where my front bumper separated from the towbar on one side. This was a very scary moment. I was able to get the vehicle stopped using the one remaining connection, but this was a struggle to do while going down hill on a 2 lane highway. The jeep was in the oncoming lane, and required me to move over to shoulder a lot more than I wanted to. Had it broke away at that point, it would have killed someone in oncoming traffic.

I don't care about the laws, rules, or any other reasoning--Supplemental brakes are just common sense and will save a life.

If my vehicle killed someone because I was too cheap to do it right, I don't think I could live with myself.
What he said!!!!
In the OP's case, he is trying to tow a Jeep with a gas motorhome, he will need all the auxiliary braking he can get in a panic stop.
 
This is not necessarily true.
A 3/4 ton gasoline CC pickup can tow more than my MH is rated to tow. The F53 has a beefier chassis and brakes with a similar engine/tranny combo.
My hitch is limited to 5k.
Is my RV? I need to find out...
Please let us know which chassis you have. The Ford F53 is available in 22k, 24k, and 26k versions. I could not find that information on the Georgetown website for your year model. There should be a nameplate with both the GVWR and GCWR. A lot of times it is near the drivers seat.
 
Please let us know which chassis you have. The Ford F53 is available in 22k, 24k, and 26k versions. I could not find that information on the Georgetown website for your year model. There should be a nameplate with both the GVWR and GCWR. A lot of times it is near the drivers seat.
If you had scrolled down to the next post, you would have seen the chassis info. The plate does not list GCWR.
 
So I'm ready for the flack on this!

5000 is based on hitch weight. The hitch can handle 500. An equalizer hitch can change that 5000 number!

What concerns me is the warning about the vehicle capacity!!! Most front engine MHs have extended frames, and the joint has been known to fail. This applies to toweds as well as pull trailers.

In short, a class 3 receiver should be capable enough with an equalizer hitch, to pull the trailer loaded with your Jeep!!!! Just remember my warning about that compromised frame!!!
If the hitch itself is capable of towing 5000 lbs, how is an equalizer hitch going to up that? It may reduce tongue weight, but not overall towing weight.
The extended frame/joint failure is interesting. I'm going to look when it quits raining.
 
If the hitch itself is capable of towing 5000 lbs, how is an equalizer hitch going to up that? It may reduce tongue weight, but not overall towing weight.
The extended frame/joint failure is interesting. I'm going to look when it quits raining.
Basically, I read manufacturers data. Of course I read what applies to my personal needs.

For instance, my class 4 hitch has a tow capacity of 10000 and a tongue of 1000.

However that capacity is increased to 14000 and 1400 respectively when a equalizer hitch is used. Oh! The greatest issue would be twist on the welds that would not be the same therefore the capacity difference!

Typically a class 3 is capable of 8000 and 800. The frame is a big factor that can change ratings drastically! No matter what hitch, the weak link establishes the final number. What the RV number is, is the final and only number you really need to avoid exceeding.

Check with Curt after you know what the RV manufacter has to say.

Personally, I would rather trailer, but I am the oddball! Reason is I value being able to back up, when I make a mistake on my route. Some here know the hassle flat towing can be when that happens! Furthermore what you would pay for an upgraded hitch does not compare to the price to enter the flat tow arena!!!
 

Latest posts

Latest resources

Back
Top